Decide on fence position and measurements of panels & posts by creating a mud map of your site. Send a copy of your mud map to TAG for a quote / to order.

Using a stringline, mark out the desired line of the fence. Mark out all spigot positions and panel placements according to the panel & gate sizes, starting with the gate. Gaps between & below the panels should not exceed 100mm to comply with Aust. Stds AS1926.1.

Attach Spigots to Glass Panels using supplied pressure plate & rubber, ensuring not to tighten too firmly. Place the panel with the spigots attached into position & bolt down or place into cored holes. Tighten the spigots & adjust panel position to ensure they are level and plumb.

Attach the hinge & latch components of the Gate Kit to the 8mm Glass Gate as per instructions. While chocking up the gate, attach hinge & latch components of the Gate Kit to the Hinge and latch panel as per instructions. Ensure the gate self closes automatically using the tension pin to adjust the spring.